Lawn Barber

FAQs

How do I assemble my Lawn Barber?

Completely unpack everything in your Lawn Barber box then, while you charge the battery, assemble it.

Start by attaching the Stability Handle to the Telescopic Pole, then attach the Blade Guard by removing the Blade Cap, Washer and Threaded Nut and securing the Blade Guard with the Nut Screw.

Next, attach a Double-Sided Blade, add the Washer back on and screw the Threaded Nut on until it’s tight using the Socket Wrench Provided.

Now you just need to add the Flower Guard and insert the battery!

What is the longest and shortest length of the telescopic pole?

The height range of the telescopic pole (not including the handle or the trimmer head) is 45cm-81cm.

How do you adjust the head to make Lawn Barber an edger?

There is a green button on the hinge of the Lawn Barber’s trimmer head. Press and hold the button then tilt the head to switch between the trimming and the edging positions.

What is the RPM of the Dual-Sided Cutting Blade?

The Lawn Barber’s Dual-Sided Cutting Blade spins at up to 10,000RPM.

How long does the Lawn Barber battery last?

Lawn Barber’s run time is up to 50 minutes.

How long does it take to charge Lawn Barber?

It takes up to 2-3 hours to fully charge Lawn Barber.

How do I replace the Dual-Sided Cutting Blade?

You should always remove the battery before replacing the Dual-Sided Cutting Blade. Once the battery has been removed, unscrew the Nylon Threaded Nut with the Socket Wrench Provided, remove the Washer and the used Dual-Sided Cutting Blade. Replace the Blade with a new one and put the Washer back on. Finally, screw on a new Nylon Threaded Nut and dispose of the used Blade and Nut.